How to Install Stair Treads and Risers like a Pro
Most fundamentally, stair tread is the "step" or portion of the staircase upon which one walks. Treads on a stair can feature an ornamental detail referred to as "nosing", typically utilized on the border of the Stair Treads.
Slippery stairs are a threat for severe falls but the correct stair treads will avoid accidents and provide reassurance. If you wish to know the best anti slip stair tread type, then synthetic carpet stair treads top the list.
The treads offer great grip, lower slips and falls, and are simple to install. Their textured surface offers better traction, thus making stairs safer for kids, old people, and pets. And, of course, eco-friendly carpet options bring safety and sustainability into the picture as well. Oak tread and riser cladding is a new product which is easily fitted on your own staircase.
Preparing to Install
Preparation is the key to a successful install, so let's ensure you have everything you need and where to begin.
Tools and Material Needed
Before you get started, ensure you have all your ducks in a row with the right tools and material. A carpenter's square, sandpaper or a sander, glue, nails or screws, measurement tape, a saw, a level, and wooden stair treads and risers are required.
Measuring and Cutting
Measure twice, cut once this saying couldn’t be truer here. Measure the width and depth of each step. Make sure your wood stair risers and treads fit perfectly by cutting them. You want a little bit of an overhang on each tread for a finished look.
Step-by-Step Installation Guide
So now that you're all prepared and ready, let's go step by step to actual installation of your wood Stair Treads and Risers.
Do You Install Risers and Stair Treads from the Top or the Bottom?
You will have to install the stair treads and risers from the bottom and work upwards. It is like climbing a ladder you will not begin from the top. This gives you a solid foundation to build from as you go up.
How to Install Stair Treads and Risers over Existing Stairs
- If you already have stairs and you are only replacing risers and treads, this is what you must do.
- Take off any existing coverings and strip the stairs so that they are bare and clean.
- Then, apply some adhesive to the back of each riser and push it down firmly.
- Apply adhesive to the back of each tread and place it on the step.
- Ensure that it is aligned with the riser below it.
- After all is in alignment, secure the treads and risers with nails or screws so they will not move.
- Simply continue step by step until all treads and risers are in position.
Finishing Touches
After you have all of the stair treads and Stair Risers in, sand over the rough areas.
Then finish it off with your choice of finish. Stain, paint, or seal, this will seal the wood and give it a neat appearance.
Comments
Post a Comment